7.6.4 Calibration of 45 Degrees
Enter 45 in
section and press on send button.
Place 45 degrees calibration apparatus between miter and saw as shown in below figure.
If angle is bigger than 45 degrees, enter a smaller value to target section and press on send button.
If angle is smaller than 45 degrees, enter a bigger value to target section.
When 45 degrees is achieved, press on
button to confirm the process.
7.6.5 Calibration of 90 Degrees:
r 90 in
section and press on send button.
Place 90 degrees calibration apparatus between miter and saw as shown in below figure
If angle is bigger than 90 degrees, enter a smaller value than 90 degrees to target section and press on send button. If it is
smaller than 90 degrees, enter a bigger value than 90 degrees to target section.
45