YILMAZ PCC 6505 Manual page 43

 Press on
position of saw angle is identified, the red background turns into green.
 Press on
reference position of saw angle in Z- axis is identified, the red background turns into green.
7.6 CALBRATION
7.6.1 Length Calibration
 Provide a profile whose length is smaller than 2 meter.
 Measure the length of profile.
 Enter the measured length in
 Press on
 Robot holds the profile automatically.
 Move the profile by using
 Clamp the profile by closing the pistons.
 Start the operation by pressing on
 When the operation is finished, open the pistons.
 Remove profile without moving the robot.
 Measure the length of rest of the profile.
 Enter the measured value in
 Enter the measured value in section.
 When all required values are entered, press on
calibration values and completes calibration.
7.6.2 Saw Height Calibration
 Enter cutting speed of saw in
 Enter the acceleration of saw's cutting speed in
 Enter the deceleration of saw's cutting speed in
 Before starting height calibration of the saw, identify the reference of saw in Z-axis.
button to identify only the reference position of processing unit saw angle. If reference
button to identify only the reference position of processing unit saw angle in Z- axis. If
buttons until the profile is placed under the saw.
section.
button on the screen.
button.
section.
button. Machine automatically calculates all the
section.
section.
section
43