Installation Of The Machine; Preparation; Connecting To Power Source; Machine's Safety Information - YILMAZ PCC 6505 Manual

5. INSTALLATION OF THE MACHINE

5.1 Preparation

5.1.1 The machine size and weight measurements, given the technical specification sheet.The ground, where the machine
will be placed, should be even, solid enough to bear the weight of the machine.
5.1.2 The machine should be located approx. 100 cm away from the rear wall. On the backside of the machine you will find
connection tube for the collection of burr and swarf, hydro-pneumatic system, cable channels, power supply connection plug.
5.1.3 You can provide the balance of the machine with adjustable counterforts in the bottom part.

5.2 Connecting to Power Source

5.2.1 Electrical connection must be made by a licensed electrician
5.2.2 The power outlet socket on the machine should be available.
5.2.3 Plug the machine to a grounded socket.
5.2.4 Mains voltage of the machine is optional as 400 V 50 Hz.
5.2.5 Check the supply voltage. The source voltage must be in accordance with the data
on the machine's label.
5.2.6 After electrical connection is made, machine must be operated in idle running and it must be controlled whether
rotation directions of cutting tools are correct or not and if the rotation direction is wrong, appropriate connection must be
made.

6. MACHINE'S SAFETY INFORMATION

6.1 Lifting, installation, electric maintenance of the machine should be carried out by qualified personnel only.
6.2 Routine maintenance and scheduled maintenance should be carried out by qualified personnel after unplugging the
machine first.
6.3 Ensure that the machine has been cleaned, tested and maintained before starting to operate it.
6.4 Check the safety devices, power cable and moving parts regularly. Don't operate the machine before having replaced
defective safety devices or faulty parts.
6.5 Never replace the cutting tools before unplugging first.
6.6 Keep foreign materials away from the working area of the machine, keep away from the machine's moving parts.
6.7 Do not work on the machine by removing the protective parts
The safety data have been defined above. In order to prevent physical damage or damage to the
equipment, please read the safety information carefully and keep the manual always in an easy
accessible place.
7.

OPERATION

7.1 START- UP of MACHINE
7.1.1 Turn on main power switch.
7.1.2 Wait for the operation of the computer.
7.1.3 When computer completes starting up, double click on
7.1.4 Commercial message screen opens. Touch the screen to skip the advertisement page

7.2 CHOOSING CUTTING LIST

7.2.1 Open the main screen.
7.2.2 Touch on icon.
7.2.3 Define the required position in the page and choose the list.
to run software.
40