YILMAZ PCC 6505 Manual page 44

 Calibration is performed in this screen on
 Enter the maximum stroke that saw can reach along Z- axis in
 Place a work piece on the table whose height is measured.
 By using the
 Remove the work piece and lower the saw about the height of work piece.
 Press on saw height calibration
 The value appears automatically in
 Remove the work piece from the table.
 By using the
saw is its ground zero.
 Press on saw height calibration
 The value appears automatically in
7.6.3 Saw Angle Calibration
 Enter the cutting speed of saw in
 Enter the acceleration of saw while turning to required angle in
 Enter the deceleration of saw while turning to required angle in
 Identify the reference of saw before starting angle calibration.
 First calibrate the angle of 45 degrees.
 Use the
 By using the
 Press on
buttons, lower the saw until it touches on the work piece.
button.
buttons, lower the saw about the height of work piece. The new position of the
button.
section for 45 degrees calibration.
buttons, lower the saw to which the adjusting miter can be placed.
button on the screen.
section.
section.
section.
section.
section.
section.
section.
44