Tiller Handle Height/Angle Adjustment (Optional Equipment) - TOHATSU BFT 75A Series Owner's Manual

Tiller Handle Height/Angle
Adjustment (optional equipment)
The tiller handle height and angle can
be adjusted to three positions by
changing the installation direction of
the height adjustment block. Select a
suitable height and angle for the
operator and secure the block.
1. Raise the tiller handle and remove
the 8 × 28 mm flange bolt and the
height adjustment block.
2. Pull down the tiller handle.
Determine the height adjustment
block installation direction and
secure the block with the 8 × 28
mm flange bolt.
(Tiller Handle)
HANDLE ANGLE: 13°
HANDLE ANGLE: 7°
Install the height adjustment block
so that the selected angle of the
tiller handle is in this position.
HEIGHT
8 × 28 mm
ADJUSTMENT
FLANGE BOLT
BLOCK
BEFORE OPERATION
HANDLE
ANGLE: 21°
HANDLE ANGLE: 7°
HANDLE ANGLE: 13°
HANDLE ANGLE: 21°
11.7 in
(298 mm)
14.2 in
(361 mm)
17.2 in
(438 mm)
HEIGHT
Reference point
53