TOHATSU BFT 75A Series Owner's Manual page 71

(Tiller Handle)
ON
OFF
IGNITION SWITCH KEY
(Multi-Function Tiller Handle)
ON
OFF
IGNITION SWITCH KEY
5. Turn the ignition switch key to the
START position and hold it there
until the engine starts.
START
When the engine starts, release the
key, allowing it to return to the ON
position.
If the engine fails to start within 5
seconds, release the key and wait at
least 10 seconds before operating
the starter again.
• Using the electric starter for
more than 5 seconds at a time
will overheat the starter motor
START
and can damage it.
• Turning the ignition switch key to
the START position while the
engine is running can damage
the starter motor and flywheel.
Also, as the engine warms up, the
throttle grip can be turned to the
SLOW position without stalling.
OPERATION
6. Before getting underway, allow the
engine to warm-up sufficiently to
ensure good performance.
Above 41°F (5°C), warm-up the
engine for at least 3 minutes.
Below 41°F (5°C), warm-up the engine
for at least 5 minutes at 2,000 rpm.
• If the engine is not properly
warmed up before raising the
engine speed, the buzzer and
overheat indicator may activate
and the engine speed will be
automatically reduced.
• The cooling system may freeze in
areas where the temperature
reaches 32°F (0°C) or below.
Cruising at high speed without
warming the engine up may
cause engine damage.
During the warm-up period, check
the oil pressure indicator (p.42),
overheat indicator (p.43), and
cooling system indicator (p.44).
69