TOHATSU BFT 75A Series Owner's Manual page 51

<Display>
Steps 1
Outboard
—
motor
Display Switch ON
Not shown
Maintenance
Maintenance
indication on
indication
display
NMEA2000-compatible display:
• Follow instructions for the display.
• If the display allows selection of notification to be preset, select "Notify" (or
equivalent).
• Turn on the power supply to the display before turning on the ignition switch
of the outboard motor.
• The indication may differ, depending on the type of display.
When "Periodic Maintenance" is indicated:
1. Have the periodic maintenance performed without delay after returning to
port.
2. Reset the hour counter.
If not reset, the maintenance indication will remain in the display, and the
hour count until the next maintenance will be in error.
2 3
Ignition switch
Start engine
ON
— —
Shown Shown
Maintenance Maintenance
indication indication
CONTROLS AND FEATURES
When the periodic maintenance is
conducted before "Periodic
4
Maintenance" is indicated, reset the
hour counter.
Gear at F or R
If not reset, the hour count until the
next maintenance will be in error.
—
Not shown
Maintenance
indication
49