TOHATSU BFT 75A Series Owner's Manual page 63

Hide thumbs Also See for BFT 75A Series:
Table of Contents

Advertisement

If the engine fails to start within 5
seconds, release the key and wait at
least 10 seconds before operating
the starter again.
• Using the electric starter for
more than 5 seconds at a time
will overheat the starter motor
and can damage it.
• Turning the ignition switch key
to the START position while the
engine is running can damage
the starter motor and flywheel.
MAXIMUM FAST IDLE
FAST IDLE
RANGE
6. Before getting underway, allow the
engine to warm-up sufficiently to
ensure good performance.
Above 41°F (5°C), warm-up the
engine for at least 3 minutes.
Below 41°F (5°C), warm-up the
engine for at least 5 minutes at
2,000 rpm. Raise the fast idle lever
to achieve approximately 2,000
rpm.
OPERATION
• If the engine is not properly
warmed up before raising the
engine speed, the buzzer and
overheat indicator may activate
and the engine speed will be
automatically reduced.
• The cooling system may freeze in
areas where the temperature
reaches 32°F (0°C) or below.
Cruising at high speed without
warming the engine up may
cause engine damage.
61

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bft75a lrt seriesBft90a lrt seriesBft90a xrt seriesBft75a k1Bft90a k1Bft 90a

Table of Contents