Dmx Mode; Set The Dmx Starting Address; Select The Dmx Channel Mode; Auto, Stand-Alone, & Built-In Program Modes - Blizzard Lighting SwitchBlade Micro Manual

DMX Mode

Allows the unit to be controlled by any universal DMX controller.
Set the Starting DMX Address:
The default mode for the fixture is DMX, so the first menu item that you can edit is the
starting DMX address.
1.) Navigate the menu using the <MENU> button until you reach A001.
2.) Push the <ENTER> button.
3.) Use the <UP/DOWN> buttons to select a DMX channel from 001-512.
4.) Press the <ENTER> button to confirm.

Select the DMX Channel Mode:

1.) Navigate the menu using the <MENU> button until you reach CH--.
2.) Push the <ENTER> button.
3.) Use the <UP/DOWN> buttons to select either CH11 or 13CH mode.
4.) Press the <ENTER> button to confirm.
Auto, Stand-Alone, & Built-in Program Modes:
Allows a single or Master/Slaved units to run factory installed programs at user selectable speeds.

Auto Mode:

1.) Navigate the menu using the <MENU> button until you reach Au--.
2.) Push the <ENTER> button.
3.) Use the <UP/DOWN> buttons to select either Au01 (fast) or Au02 (slow).
4.) Press the <ENTER> button to confirm.

Sound Active Mode:

1.) Navigate the menu using the <MENU> button until you reach Sond.
2.) Push the <ENTER> button.
3.) Use the <UP/DOWN> buttons to select either So.on (On) or So.of (Off).
4.) Press the <ENTER> button to confirm.

Manual Adjustments:

1.) Navigate the menu using the <MENU> button until you reach nAnu.
2.) Navigate the submenu using the <UP/DOWN> buttons until you reach H--- (Pan), Y---
(Tilt), r--- (Red). 9--- (Green), b--- (Blue), or u--- (White) then hit <ENTER>.
3.) Using the <UP/DOWN> buttons, select your desired value for each between
x000-x255, then hit <ENTER> to confirm.

Reverse Pan

1.) Navigate the menu using the <MENU> button until you reach rPoF.
2.) Push the <ENTER> button.
3.) Use the <UP/DOWN> buttons to select either rPoF (Off) or rPon (On).
4.) Press the <ENTER> button to confirm.

Reverse Tilt

1.) Navigate the menu using the <MENU> button until you reach rtoF.
2.) Push the <ENTER> button.
3.) Use the <UP/DOWN> buttons to select either rtoF (Off) or rton (On).
4.) Press the <ENTER> button to confirm.

Reverse (Flip) the Menu Display

1.) Navigate the menu using the <MENU> button until you reach rdoF.
2.) Push the <ENTER> button.
3.) Use the <UP/DOWN> buttons to select either rdoF (No) or rdon (Yes).
4.) Press the <ENTER> button to confirm.
SwitchBlade™ Micro User Manual Rev. A
Page 14
(c) Copyright 2014 Blizzard Lighting, LLC