Control Panel Menu Structure
Address
Work Mode Set
X Mirror Set
Y Mirror Set
X Run Set
Y Run Set
Graph Mode Set
Speed Set
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
Set the Starting DMX Address
1.) Navigate the menu to reach Address, and press the <ENTER> button.
2.) Use the <UP/DOWN> buttons to select a channel from 001-512, press <ENTER>.
Run Mode
1.) Navigate the menu to reach Work Mode Set, and press the <ENTER> button.
2.) Highlight DMX, Auto, or Sound and press the <ENTER> button.
Slave Mode
1.) Daisy chain the fixtures DMX in/out. The 1st fixture will be the master fixture.
2.) On slave fixtures, navigate to Work Mode Set, select Slave, and press <ENTER>.
Mirror Symmetry Mode
Reverse/flip the output of either X, Y, or both.
1.) Navigate the menu to reach X Mirror Set or Y Mirror Set, and press <ENTER>.
2.) Select Yes to enable, or No to disable. Press <ENTER> to confirm.
Running Mode Settings
Fine tune the position of either X, Y, or both.
1.) Navigate the menu to reach X Run Set or Y Run Set, and press <ENTER>.
2.) Highlight Run for default, or Stop for incremental positioning, and press <ENTER>.
Graphic Mode Settings
1.) Navigate the menu to reach Graph Mode Set, and press <ENTER>.
2.) Select Beam Show or Animal Show, incrementally adjust, then press <ENTER>.
Speed Settings
1.) Navigate the menu to reach Speed Set, and press <ENTER>.
2.) Use the <UP/DOWN> buttons to adjust the speed settings, then press <ENTER>.
Laser Blade™ G Manual - Rev. B
<ENTER>
To choose a DMX address from 001-512
Auto
Auto run mode
Sound
Sound active mode
DMX
DMX mode
Slave
Slave mode
Yes/No
X mirror symmetry (reverse) on/off
Yes/No
Y mirror symmetry (reverse) on/off
Run
<ENTER>
Stop
X Position (+/-) 1 <ENTER>
Run
<ENTER>
X Position (+/-) 1 <ENTER>
Stop
<ENTER>
<UP/DOWN> to choose beams/animations
<ENTER>
<UP/DOWN> to increase/decrease speed
Page 11
© 2020 Blizzard Lighting, LLC