Dmx Mode; Setting The Dmx Channel Mode; Slave Mode; Dimming Mode Settings - Blizzard Lighting Weather System EXA Manual

DMX Mode

Allows the unit to be controlled by any universal DMX controller.
Setting the Starting DMX Address:
1.) To select a starting DMX address for your fixture, navigate the main menu to reach ADDR,
then press <ENTER>. Now use the <UP/DOWN> buttons to select any stating DMX address
value ranging between 001-512, then press <ENTER> to confirm your choice.

Setting the DMX Channel Mode:

1.) To select a DMX channel mode, navigate the main menu to reach SET, then press
<ENTER>. Then use the <UP/DOWN> buttons to highlight CHMD, and press <ENTER>.
From here you can select your desired DMX channel mode, and press <ENTER> to confirm.

Slave Mode:

1.) Daisy chain the fixtures via DMX In/Out, with the controller at the beginning.
2.) Set starting DMX channels and DMX channel modes all to match the master fixture.
3.) There is nothing else to it! The first fixture in the DMX chain is the master fixture, and the
following fixtures will follow the master.

Dimming Mode Settings:

Allows users to set the fixture to use 1 of 4 (x2) dimming curve settings for smoother (and slower)
dimming capabilities. In the control panel menu, there are two settings for each curve that are
distinguishable from one another by the trailing dot.
Linear Curve
(LIN, LIN.)
*The curve settings with the trailing dot adds a bit more delay to the curve for a smoother effect.
1.) Use the <MENU> and <UP/DOWN> buttons to navigate to SET and press <ENTER>,
then <UP/DOWN> buttons again to scroll to DIM, and press the <ENTER> button.
2.) Now use the <UP/DOWN> buttons to highlight either LIN (Linear), SQR (Square), ISQR
(Inverse Square), SCUR (S-Curve), LIN. (Smooth Linear), SQR. (Smooth Square), ISQR.
(Smooth Inverse Square), or SCUR. (Smooth S-Curve), then hit <ENTER>.

Static Colors and Strobe Effects:

Allows the user to manually adjust RGBAW+UV color balance and strobe.
1.) Use the <MENU> and <UP/DOWN> buttons to navigate to STAT and press <ENTER>,
then <UP/DOWN> buttons to select R/G/B/A/W/UV or SHUT (strobe) and press the
<ENTER> button.
2.) Now use the <UP/DOWN> buttons to highlight any value ranging from 0-255 to adjust the
intensity level, and press the <ENTER> button to confirm.

LED Display On/Off:

1.) Use the <MENU> and <UP/DOWN> buttons to navigate to SET and press <ENTER>,
then navigate to DISY, and press the <ENTER> button.
2.) In DISY, you can set the LED menu display to be continually on by selecting ON, or shut off
after 2 minute of inactivity by selecting 2MIN. Press <ENTER> to confirm.
Weather System EXA Manual Rev. A
Square Law
(SQR, SQR.)
DMX% DMX%
Inverse Square Law
(ISQR, ISQR.)
DMX%
Page 12
S-Curve
(SCUR, SCUR.)
DMX%
© 2016 Blizzard Lighting, LLC