Table of Contents
Advertisement
DMX Values In-Depth (11-Channel Mode)
Channel
1
2
3
4
5
6
7
8
9
10
11
Troubleshooting
Symptom
Fixture Auto-
Shut Off
Beam is Dim
No Light Out-
put
Chase Speed
Too Fast/Slow
No Power
No Response
to Audio
Fixture Not
Responding /
Responding
Erratically
If your problem isn't listed, or if problems persist,
please contact support: support@blizzardlighting.com.
SwitchBlade™ Micro User Manual Rev. A
Value
What It Does
000 <--> 255 Pan (0-540°)
000 <--> 255 Tilt (0-270°)
000 <--> 255 Fine Pan (fast <--> slow)
000 <--> 255 Fine Tilt (fast <--> slow)
000 <--> 255 Pan/Tilt Speed (slow <--> fast)
000 <--> 255 Dimmer (0% <--> 100%)
000 <--> 255 Strobe (slow <--> fast)
000 <--> 255 Red Intensity (0% <--> 100%)
000 <--> 255 Green Intensity (0% <--> 100%)
000 <--> 255 Blue Intensity (0% <--> 100%)
000 <--> 255 White Intensity (0% <--> 100%)
Solution
Check the fan in the fixture. If it is stopped or moving
slower than normal, the unit may have shut itself off due to
high heat. This is to protect the fixture from overheating.
Clear the fan of obstructions, or return the unit for service.
Check optical system and clean excess dust/grime. Also
ensure that the 220V/110V switch is in the correct position,
if applicable.
Check to ensure fixture is operating under correct mode, IE
sound active/auto/DMX/Etc., if applicable. Contact service
for more information.
Check to ensure proper setup of speed adjustment.
Check fuse, AC cord and circuit for malfunction.
Verify that the fixture is in "Sound Active" mode.
Adjust Audio Sensitivity, If Applicable.
Make sure all connectors are seated properly and securely.
Use Only DMX Cables.
Install a Terminator.
Check all cables for defects.
Reset fixture(s).
Page 16
(c) Copyright 2014 Blizzard Lighting, LLC
Advertisement
Table of Contents
