Getting It Out Of The Box Congratulations on purchasing one way cool, way flexible, way original LED strip light! Now that you’ve got your StormChaser™ (or hopefully, Storm- Chasers!), you should carefully unpack the box and check the contents to ensure that all parts are present and in good condition. If anything looks as if it has been damaged in transit, notify the shipper immediately and keep the packing material for inspection.
• Never disconnect the power cord by pulling or tugging on the cord. • Avoid direct eye exposure to the light source while it is on. Caution! There are no user serviceable parts inside the unit. Do not open the housing or attempt any repairs yourself. In the unlikely event your unit may require service, please contact Blizzard Lighting at sup- port@blizzardlighting.com. Page 4 StormChaser Manual Rev. C Copyright (c) 2012 Blizzard Lighting, LLC...
Global White Intensity Pixel 5 Global Intensity Pixel 6 Global Intensity Pixel 7 Global Intensity DMX Quick Reference - 2 Channel Mode Channel What It Does Built-in Programs Speed Control Page 5 StormChaser Manual Rev. C Copyright (c) 2012 Blizzard Lighting, LLC...
Figure 1: The StormChaser™ Pin-Up Picture High Power LED’s Mounting Bracket & Adjustment Screw Anodized Aluminum Enclosure Figure 2: The Rear Connections AC Power In DMX In DMX Out Microphone MENU UP DOWN ENTER Menu Buttons LED Display Menu AC Power Out Page 6 StormChaser Manual Rev.
Remove the damaged fuse from its holder and replace with exact same type fuse. Insert the fuse holder back in its place and reconnect power. Connecting A Bunch of StormChaser™ Fixtures You will need a serial data link to run light shows using a DMX-512 controller or to run shows on two or more fixtures set to sync in mas- ter/slave operating mode. The combined number of channels required...
(input). Note: It doesn’t matter which fixture address is the first one connected. We recommend connecting the fixtures in terms of their proximity to the controller, rather than connecting the lowest fixture number first, and so on. Step 3: Connect other fixtures in the chain from output to input as above. Place a DMX terminator on the output of the final fixture to ensure best communication. Page 8 StormChaser Manual Rev. C Copyright (c) 2012 Blizzard Lighting, LLC...
Do not mount to surfaces with unknown strength, and ensure properly “rated” rigging is used when mounting fixtures overhead. Adjust the angle of the fixture by loosening both knobs and tilting the fixture. After finding the desired position, retighten both knobs. • When selecting installation location, take into consideration lamp replacement access (if applicable) and routine maintenance. • Safety cables MUST ALWAYS be used. • Never mount in places where the fixture will be exposed to rain, high humidity, extreme temperature changes or restricted ventilation. Page 9 StormChaser Manual Rev. C Copyright (c) 2012 Blizzard Lighting, LLC...
4. OPERATING ADJUSTMENTS The Control Panel All the goodies and different modes possible with the StormChaser™ Are accessed by using the control panel on the side of the fixture. There are 4 control buttons below the LED display which allow you to navigate through the various control panel menus. <MENU> Is used to navigate to the previous higher-level menu item. <UP> Scrolls through menu items and numbers in ascending order.
2nd digits) on the LED control panel menu, and the <DOWN> button adjusts its program (3rd & 4th digits). S --- <ENTER> Sound Active Modes SO00 - SO09 LED dB Meter / Mic Sensitivity S10O - S109 Sound Active 1, Effects Run When Silent S20O - S209 Sound Active 2, Effects Stop When Silent Page 11 StormChaser Manual Rev. C Copyright (c) 2012 Blizzard Lighting, LLC...
Use Only DMX Cables. Install a Terminator. Check all cables for defects. Reset fixture(s). Fixture Moving On Its Verify proper mode of operation. Is the fixture in “Auto” mode? If your problem isn’t listed, or if problems persist, please contact support: support@blizzardlighting.com. Page 13 StormChaser Manual Rev. C Copyright (c) 2012 Blizzard Lighting, LLC...
Damage incurred in shipping is the responsibility of the shipper, and must be reported to the carrier immediately upon receipt of the items. Claims must be made within seven (7) days of receipt. Page 14 StormChaser Manual Rev. C Copyright (c) 2012 Blizzard Lighting, LLC...