Graco SaniForce SDU Series Manual page 44

Electro-pneumatic Control Panel Display Screens
Event Type Event Event Type Type Event Event Event Description Description Description
Deviation USB data format
error
Deviation USB file header error
Deviation USB not connected
Deviation USB operation failed
Advisory
USB Export
Successful
Advisory USB Import
Successful
Record System
Depressurization
Record System Startup
Record System Time
Changed
* Modules must be installed in the following order, from left to right:
X20BC1083
X20PS9400
X20CM8281
X20DS438A
X20AO2622
X20DO8322
44
Error
Error Error
Code Code Code Cause Cause Cause
WSU2 The data in the file targeted by a
USB import contains incorrectly
formatted data.
WSU1 The information in the header of
the file targeted by a USB import
contains an incorrect or incorrectly
formatted Software Part Number
or Software Version.
CCU0 A USB device is not connected to
the system.
WXU0 A USB import or export command
was not able to be completed: an
unspecified error occurred during
the operation.
EQUE USB Export operation completed
successfully.
EQUI USB Import operation completed
successfully.
P010 A depressurization sequence was
completed.
ELC0 The system started up and the
boot sequence completed.
ECT0 The system time was changed by
more than one minute.
Fix Fix Fix
Verify data is formatted correctly. No
commas or new lines should be inserted
while modifying a file for importing into
the system.
Verify Software Part Number and
Software Version and correct and
formatted correctly in the file header.
Verify the USB device is compatible
with the system, formatted properly, and
inserted fully into one of the USB ports
on the back of the screen unit. A USB
device can take up to 10 seconds to be
recognized by the system once inserted.
Check that the USB device is fully
inserted into the USB ports on the back
of the screen unit. If importing, check
formatting of data in files and remove any
unnecessary files from the directory.
N/A
N/A
N/A
N/A
N/A
3A5402J