Graco SaniForce SDU Series Manual page 29

Icon / / / Field Field
Icon Icon Field
Current Recipe Current Current Recipe Recipe
Partial Drum Drum
Partial Partial Drum
Batching
Batching Batching
Available statuses:
Condition not met
Condition met
Seal Inflated Inflated
Seal Seal Inflated
System System Loaded System Loaded Loaded
Drum Low Low
Drum Drum Low
Drum Drum Empty Drum Empty Empty
Auto Sequence Auto Auto Sequence Sequence
Complete
Complete Complete
Batching Sequence Batching Batching Sequence Sequence
Complete
Complete Complete
3A5402J
Description
Description Description
AUTO AUTO SEQUENCE AUTO
Name of the recipe selected for unloading this drum. Click in this field to display the
recipe selection screen.
Start Start Start
Begin drum unloading at the current state of the automatic sequence. If the sequence
was stopped before completing, the drum unloading resumes at the point where the
unloading was stopped.
Stop Stop Stop
Stop drum unloading. If the automatic sequence is not complete, the drum unloading
status is retained so that the sequence can be completed if started again.
Reset Reset Reset
Resets the automatic sequence state, deflates the seal, and if "Auto Raise" is selected
in the current recipe, will raise the ram.
Auto Auto Sequence Auto Sequence Enabled Sequence Enabled Enabled
Flashes in the upper-left corner of the screen next to the date and time once the
automatic sequence has been activated. Once the sequence is fully enabled, the icon
will also flash over the Start button.
NOTE: NOTE: If the Start button is released too soon during the loading process, then the NOTE:
sequence will stop. The icon will still flash next to the date and time to show that
loading started, but did not finish. To continue the automatic sequence, press and
hold the Start button until the icon flashes over the Start button.
Available settings:
Partial drum
Not a partial drum
If checked, unload the batch size specified in the Batch Amount field. If unchecked,
unloading will not automatically stop until the drum has been emptied.
Ram position in the drum.
Note: The red line indicates the approximate ram plate position at which the Drum
Note: Note:
Low status flag will be set.
STATUS MESSAGES STATUS STATUS
The ram plate seal is inflated.
The pump is primed and ready to evacuate the drum. This is based on the pump
primed timer.
Ram assembly has reached the Drum Low position.
Ram assembly has reached the Drum Empty position.
The actions specified by the selected recipe have been completed. When this state is
achieved, all other status states are cleared.
Displays when Batching has been enabled. When lit, indicates that the dispensed
material value specified is achieved.
Electro-pneumatic Control Panel Display Screens
SEQUENCE SEQUENCE
MESSAGES MESSAGES
29