Graco SaniForce SDU Series Manual page 32

Electro-pneumatic Control Panel Display Screens
Icon/Field Description
Icon/Field Icon/Field Description Description
Seal Seal Inflate Seal
Press to inflate the ram plate seal.
Stop Stop Stop seal
Stop inflating or deflating the seal. To resume, press the desired seal action button,
inflate or deflate.
Seal Deflate
Seal Seal
Press to deflate the ram plate seal.
Current Job
Current Current
Details of the current batch. This element is only active if feedback has been enabled
on the I/O Settings Screen.
Complete Complete Complete Job
Press to mark the current batch as complete. Do not press if the intention is to restart
the current batch again.
Air Air Air Assist
Press and hold to blow air between the ram plate and the product to break the
adhesion between the two. The ram plate seal should be deflated before performing
this operation.
NOTE: NOTE: NOTE: Air assist will not operate unless Ram Up or Ram Hold is also selected.
Ram Ram Up Ram
Momentarily press to raise the ram assembly. The ram will continue raising until the
ram has reached the top of its travel, unless manually stopped by pressing Ram Hold.
Ram Hold
Ram Ram
Momentarily press to keep the ram at the current location.
NOTE: This is an active hold and the system may momentarily energize Ram Up to
NOTE: NOTE:
keep the ram plate from drifting. Active hold is enabled for 5 seconds after any Pump,
Ram, Seal, or Air Assist command.
Ram Jog
Ram Ram
Press and hold to lower the ram assembly. Releasing the button will stop lowering
the ram.
Ram Ram Down Ram
Momentarily press to lower the ram to the lowest position. The ram will continue
lowering until the ram has reached the bottom of its travel, unless manually stopped
by pressing Ram Hold.
32
Inflate Inflate
seal action seal action action
Deflate
Deflate
Batch Batch Batch Information
Job
Job
Job Job
Assist Assist
Up Up
Hold
Hold
Jog
Jog
Down Down
Seal Control Seal Seal Control Control
Information Information
Air Air Air Assist Assist Assist
Ram Control Control
Ram Ram Control
3A5402J