Honeywell Performance Series User Manual page 220

Performance Series Network Video Recorder User Guide
Figure 12-77 Configuring for Network Abnormalities
Figure 12-78 Configuring for Username Abnormalities
Table 12-22 Configuring for Abnormalities
Configuration
Event Type
Enable
Alarm Out
Latch
206
Description
Select from No HDD, HDD Error, No Space, Disconnect, IP Conflict,
MAC Conflict and Username.
Less Than: (For No Space configuration only) Configure the minimum
percentage of free space on the disk. An alarm lets you know when the
disk capacity is low. You need to click to enable this function.
Attempt(s) and Lock Time: (For Username configuration only)
Configure the number of login Attempt(s) before the alarm is activated
and the login screen is locked out for the specified Lock Time.
Click to enable this function.
Select the device output port, 1 or 2. Select the corresponding port(s)
so the system can activate the corresponding alarm devices when an
alarm occurs.
The system can delay the alarm output for a specified time after an
alarm ends. The value ranges from 1s to 300s.