Honeywell Performance Series User Manual page 199

Subject Enter an email subject. You can use up to 32 letters or numbers.
Attachment
Click to enable so that a snapshot can be attached to the email.
Enter the receiver's email address. You can enter up to 3 email boxes.
Receiver
You can use SSL or TSL email boxes.
The interval for sending ranges from 0 to 3600 seconds. 0 means that
there is no interval.
Note: The system will not send an email immediately when the alarm
occurs. When an alarm, motion detection, or video abnormality triggers
Interval
an email, the system sends out the email according to the interval that
is specified here. This function is very useful when there are too many
emails activated by events, which might result in an overload for the
email server.
Click to enable the email health check. The NVR sends a test email to
check the network connection.
Health Enable
After enabling Health Enable, you can configure how frequently the
NVR sends out emails to test the network connection.
Click Test to send a test email. A popup message appears to indicate
Email Test
the state of the network connection.
Configuring UPnP
UPnP allows you to establish the mapping relationship between the LAN and the public
network. Here you can also add, modify, or remove a UPnP item.
Preparing for UPnP
1. In the Windows OS, go to Start  Control Panel  Add or remove programs.
2. Click Add/Remove Windows Components, and then select Network Services from the
Windows Component Wizard.
3. Click Details, then check Internet Gateway Device Discovery and Control client and
UPnP User Interface. Then click OK to begin the installation.
4. Enable UPnP from the internet. If your UPnP is enabled in the Windows OS, then the NVR
can automatically detect it through the My Network Places.
Configuring UPnP
1. Click UPnP in the NETWORK configuration interface to open the UPnP configuration
interface.
Web Client Operation
185