Honeywell Performance Series User Manual page 208

Performance Series Network Video Recorder User Guide
Message
Log
Video Loss Detection Configurations
You can configure the system to generate a video loss alarm when the minimum amount of
video loss (as defined by you) is detected in the video.
Note Video loss does not support anti-dither, sensitivity, or region setup.
1. Click Video Detection  Video Loss under EVENT to open the Video Loss configuration
interface.
2. Setup the video loss settings and click OK to save the settings.
Figure 12-64 Video Loss Configuration Interface
The configuration for Video Loss Detection is very similar to the configuration for Motion
Detection. Please see
Camera Tampering Detection Configurations
You can configure the system to generate a camera tampering alarm when the minimum
amount of tampering (as defined by you) is detected in the video.
1. Click Video Detection  Tampering under EVENT to open the Tampering configuration
interface.
2. Setup the tampering settings and click OK to save the settings.
194
Select the check box to send a text message when motion events are
detected. Go to Network3GMobile to configure messaging
settings.
Select the check box to enable logging of motion detected events.
Motion Detection Configurations on page 190 for more information.