Honeywell Performance Series User Manual page 185

2. Click the Edit icon for the Ethernet connection that you want to modify. The Edit screen
opens.
Figure 12-37 Edit TCP/IP Screen
3. Make any changes to the TCP/IP settings as needed, and then click OK.
Table 12-12 TCP/IP Configurations
Configuration
Mode
MAC Address
MTU
IP Version
IP Address
Subnet Mask
Default Gateway
Preferred DNS
Alternate DNS
Description
There are two modes: STATIC and DHCP.
• The IP address, subnet mask, and gateway is inactive and not
configurable when you select the DHCP mode to automatically
search for the IP address.
If you select STATIC mode, then you need to manually configure the
•
IP address, subnet mask, and gateway.
• If you select DHCP mode, then you can only view the IP address,
subnet mask, and gateway. You cannot configure these values.
• If you switch from the DHCP mode to the static mode, then you
need to reset the IP parameters.
•
• The IP address, subnet mask, gateway, and DHCP are read-only
values when the PPPoE dial is OK.
Displays the MAC address. This field is not configurable.
Use the default MTU (maximum transmission unit) value.
Select the IP version, either IPv4 or IPv6.
You can use either version to access the camera's IP address.
1. Use your PC's keyboard to enter the IP address.
2. Set the Subnet mask and Default gateway.
If you selected the STATIC mode, then enter a Subnet Mask value.
If you selected the STATIC mode, then enter a Default Gateway value.
Enter the DNS IP address.
Enter an alternate DNS IP address.
Web Client Operation
171