Configuring Event Settings - Honeywell Performance Series User Manual

Performance Series Network Video Recorder User Guide
4. Use the mobile device's camera to view the QR code on the P2P screen.
5. The HonView Touch app will automatically download the NVR information and establish a
connection.
Configuring Switch Settings
Note
You can change the IP Address, Subnet Mask, and Default Gateway for setting the PoE switch
settings.
1. Click Switch under Network to open the Switch interface.
Figure 12-62 Switch Configuration Interface
2. Configure the following settings:
Table 12-19 Switch Configurations
Configuration
IP Address
Subnet Mask
Default Gateway
3. Click OK to save your settings.

Configuring Event Settings

Motion Detection Configurations
You can configure the system to generate a motion detection alarm when the minimum
amount of motion (as defined by you) is detected in the video.
1. Click Video Detection  Motion Detection under EVENT to open the Motion Detect
configuration interface.
190
This function is only available for
HEN081*4/HEN162*4/HEN163*4/HEN161*4/HEN322*4/HEN323*
4/HEN321*4/HEN642*4/HEN643*4/HEN041*3/HEN081*3/HEN16
1*3.
Description
Enter a new IP address.
Enter a new subnet mask.
Enter a new default gateway.