Camera Power Up - Arecont Vision SurroundVideo G5 Mini Installation Manual

®
SurroundVideo

Camera Power Up

This product should be installed by a qualified service technician in accordance with the
National Electrical Code (NEC 800 CEC Section 60) or applicable local code. Make sure
that your installation of wires complies with Electrical Code of the local government where
the camera is installed and no bare wires are exposed.
1. Connect the camera to a PoE port on 100Mbps network PoE switch using an Ethernet cable as
shown in the image below.
Reference #
1
2. If the camera is powered by an outside power supply, 18~48VDC (green and brown wires) or
24VAC(red and black wires), connect the power cable.
CAUTION! Make the connections inside a watertight compartment. Isolate unused power
wires individually.
After connections are made, ensure that the watertight compartment is tightly closed and
cables and conduits are properly sealed to prevent ingress of water.
3. Connect the PoE switch to your computer's network port using an Ethernet cable.
Page | 30 support@arecontvision.com
+1.818.937.0700 877.CAMERA.8
G5 Mini
Description
PoE Connector
www.arecontvision.com avsales@arecontvision.com
Installation Manual