Corner Mount - Arecont Vision SurroundVideo G5 Mini Installation Manual

®
SurroundVideo

Corner Mount

For a corner mount installation, the AV-WMJB wall mount, AV-CRMA corner mount, and MD-
CAP mount cap are required (sold separately). A corner mount should only be attached onto
hard corner surfaces including wood, plastic, metal, and concrete.
1. Using the Mounting template, prepare the mounting provisions for the camera installation.
2. Connect the wall mount cap and wall mount.
3. Attach the Junction Box Adapter to the Corner Mount Adapter
4. Remove the conduit plug on the junction box adapter and connect ¾" NPT conduit to the
junction box adapter
NOTE: Use silicon or water pipe seal tape to make sure no water leakage between conduit pipe
and junction box adapter.
5. Run the Ethernet cable and outside power cable (if necessary) through the supplied rubber
gasket and then through the Junction Box Adapter and AV-WMJB, Wall Mount Adapter. Ensure
the gasket is seated properly.
6. Attach the Wall Mount Adapter (AV-WMJB) to the Corner Mount Adapter (AV-CRMA) as shown
in Figure 2.
Page | 21 support@arecontvision.com
+1.818.937.0700 877.CAMERA.8
G5 Mini
as shown in Figure 1.
Figure 1: Attach conduit to SV-JBA junction box adapter
Reference #
1
Connect ¾" NPT conduit to junction box adapter
2
www.arecontvision.com avsales@arecontvision.com
Description
Remove conduit plug
(ensure use of water seal tape)
Installation Manual
as shown in Figure 1.