Adjusting The Pan, Tilt And Focus - Arecont Vision SurroundVideo G5 Mini Installation Manual

®
SurroundVideo

Adjusting the Pan, Tilt and Focus

1. Remove the dome cover by loosening the captive fasteners with the supplied security L-key
screwdriver.
2. Power on the camera to adjust the pan, tilt and focus.
3. To adjust the gimbal tilt, use #2 Phillips screwdriver to loosen two Philips head screws on both
sides of the Gimbal, no more than two full turns. Adjust the pan and tilt to obtain the desired field
of view as shown in Figure 1. NOTE: Do not remove the screws!
Figure 1: Loose camera head to adjust the field of view
4. To adjust each lens in the 360 configuration, loosen the two set screws on the top shell with a
#1 Phillips screwdriver. Adjust each lens angle tilt as required and tighten the two set screws
show in the image below.
Page | 26 support@arecontvision.com
+1.818.937.0700 877.CAMERA.8
G5 Mini
180 configuration
www.arecontvision.com avsales@arecontvision.com
Installation Manual
360 Configuration