Reset To Factory Default - Arecont Vision SurroundVideo G5 Mini Installation Manual

®
SurroundVideo
NOTE: Wiring methods shall be in accordance with the National Electrical Code/NFPA 70/ANSI, and
with all local codes and authorities having jurisdiction. Wiring should be UL Listed and/or Recognized
wire suitable for the application.

Reset to Factory Default

1. You can reset to factory default via camera web interface or AV IP Utility. This can be done by
the following steps:
a. Open AV IP Utility and Click on Tools as seen in Figure 1.
b. Click on "Restore To Factory Default" as seen in Figure 2
NOTE: Additional information regarding the Arecont Vision
IP Utility Web Browser Manual via the Arecont Vision website.
Page | 32 support@arecontvision.com
+1.818.937.0700 877.CAMERA.8
G5 Mini
Figure 1
Figure 2
www.arecontvision.com avsales@arecontvision.com
Installation Manual
®
web interface is found separately in the AV