Pole Mount - Arecont Vision SurroundVideo G5 Mini Installation Manual

®
SurroundVideo

Pole Mount

For a pole mount installation, the AV-WMJB wall mount, AV-PMA pole mount, and MD-CAP mount
cap are required (sold separately). A pole mount should only be attached onto hard ceilings
including wood, plastic, metal, and concrete.
1. Using the mounting template, prepare the mounting provisions for the camera installation.
2. Connect the wall mount cap and wall mount.
3. Attach the Junction Box Adapter to the Pole Mount Adapter
4. Remove the conduit plug on the junction box adapter and connect ¾" NPT conduit to the
junction box adapter (Figure 1).
Reference #
1
2
NOTE: Use silicon or water pipe seal tape to make sure no water leakage between conduit
pipe and junction box adapter.
5. Run the Ethernet cable and outside power cable (if necessary) through the supplied rubber
gasket and then through the Junction Box Adapter and AV-WMJB, Wall Mount Adapter. Ensure
the gasket is seated properly.
6. Attach the Wall Mount Adapter (AV-WMJB) to the Pole Mount Adapter (AV-PMA) as shown in
Figure 2.
Page | 19 support@arecontvision.com
+1.818.937.0700 +1.818.937.0700 877.CAMERA.8 877.CAMERA.8
G5 Mini
Figure 1: Attach conduit to AV-JBA junction box adapter
Description
Remove conduit plug
Connect ¾" NPT conduit to junction box adapter
(ensure use of water seal tape)
www.arecontvision.com avsales@arecontvision.com www.arecontvision.com avsales@arecontvision.com
Installation Manual
as shown in Figure 1.