Arecont Vision SurroundVideo G5 Mini Installation Manual page 20

®
SurroundVideo
7. Use the supplied two Steel Straps to attach the Pole Mount Adapter to the pole and tighten the
compression screws as shown in Figure 2.
8. To attach the camera to the Wall Mount Adapter (AV-WMJB), reference the Installation and Wall
Mount section.
9. To configure the camera, reference the camera discovery, set-up and configuration section.
CAUTION! The captive screws must be used to properly secure the dome cover and
camera housing. Failure to use the captive fastener may result in serious injury. When
mounting the dome cover to the camera housing, ensure that the gasket is properly seated
and not folded. Failure to do so may result in water and dust ingress. Water damage from
improper installation is not covered by the warranty!
Page | 20 support@arecontvision.com
+1.818.937.0700 877.CAMERA.8
G5 Mini
Figure 2: Attach wall mount adapter to pole mount adapter
Reference # Description
1 Steel straps with compression screws
AV-WMJB wall mount
2
MD-CAP mount cap
3
Conduit
4
AV-PMA pole mount
5
Apply Teflon water seal tape to the thread of ¾" NPT
6 pipe to avoid water leakage
www.arecontvision.com avsales@arecontvision.com
Installation Manual