Table of Contents
Advertisement
1. Remove battery case. Position your thumb over the thumb grips (see
Figure F.3.1Ba) and brace your fingers against the front of the keypad.
Apply firm pressure to the panel with the thumb grips to release the latch.
2. Remove batteries. Press
a pipette tip against either
battery through the slot in the
bottom of the battery case
to remove the batteries (see
Figure F.3.1Bb).
3. Install new batteries. Insert
the spacer into the bottom
of the battery box (as shown
in Figure F.3.1Bc). Insert
new batteries by placing the
positive end into
the battery case first, then the negative end in place over the spacer (an
exploded view of the assembly is shown in Figure F.3.1Bc, or the diagram
in the battery case). Ensure that the batteries are correctly oriented.
Figure F.3.1Bc: Installing NiMH Batteries
Figure F.3.1Bb: Removing the Batteries
Maintenance
47
Advertisement
Table of Contents
