Table of Contents
Advertisement
SPd
Pipetting speed can be adjusted by pressing the Volume key in
the special function mode. Five speed settings are available:
TONE
The beep tone signals the completion of one or more steps, or
signals a warning:
• Single beep tone: end of pipetting step.
• Double beep tone: operation or programming key is not
active in current mode; insufficient dispense volume, purge
required; or illegal programming step attempted (see Section
E, Troubleshooting).
• Triple beep tone: end of pipetting sequence; end of
programming sequence.
There are three options to choose from in setting the beep tone.
ON1 sounds all tones at the appropriate times listed above. ON2
uses only double and triple beep tones. OFF turns off all tones
except for the tone to signify an illegal programming step. Press
the Special Function key twice to display "TONE" and its current
setting. To change the setting, press the Volume key. If the beep
tone is set for ON1 or ON2, the beep tone symbol " " appears
at the bottom of the display.
Note: For paced dispensing, the beep tone should be set ON1, to
prepare you for each dispense step.
Speed Setting
Slow
Medium Slow
Medium
Medium Fast
Fast
Display
S
S
z
S
z
z
S
z
z
z
S
F
z
z
z
Pipette Overview
9
Advertisement
Table of Contents
