Please Check Reader Assignment Code Set For The Id; Want To Access With Card Only, Without Password - IDTECK LX007 Manual

If the problem persists, please contact service center.
9 "ACCESS DOOR ERR" appears on the LCD when a car
d is read.
9.1

Please check reader assignment code set for the ID.

Check the Reader assignment code set for the ID of the card from a software and chang
●
e it to the right RD(Reader assignment code).
If you cannot change it from the software, from the device, see
●
SETUP MENU] >
[F7 SETUP
reader mode.
RD
RD is the Reader Assignment code for the cardholder. Entering the code "0", "3" a
ssigns both readers (Built-in Reader and Exit Reader) to grant access to the cardhol
der that is being registered, code "1" only assigns Reader#1 (Built-in Reader) and c
ode "2" assigns Reader#2 (Exit Reader). If you enter "1" in the RD field (Only Reade
r#1 assigned) and try to exit through Reader#2 (Exit Reader) then the the device g
enerates an error message ("Access Door Error") on the LCD display.
If the problem persists, please contact service center.
10 I want to access with card only, without password.
I want to access with card only, without password.
[ID Delete]of the manual and delete the ID and see
MENU] > [ID Registration] of the manual to newly create the ID with the right
[Setting Changes] >[F7
[Setting Changes] >
p.93