Figure 1-3, Top And Left Side Features - Magnum Energy MMS Series Owner's Manual

Introduction

Figure 1-3, Top and Left Side Features

1. Inverter Status Indicator – a green LED that illuminates to
provide information on the inverter's operation.
2. Power Switch – a momentary pushbutton switch that turns the
inverter on or off.
3. Negative DC Terminal (black) – the inverter's connection to
the negative terminal on the battery bank.
4. Positive DC Terminal (red) – the inverter's connection to the
positive terminal on the battery bank.
5. Input Circuit Breaker – a circuit breaker that protects the unit's
internal wiring and pass-thru relay.
6. Output Circuit Breaker – a circuit breaker that provides another
layer of overload protection. Not a branch circuit-rated breaker.
Separate AC output breakers may be required on the output.
7. Mounting Flanges (x4) – secure the inverter to shelf/wall.
8. AC Wiring Compartment - provides access for all AC input and
output connections on the inverter.
9. AC Output Connection – AC knockout for hardwiring AC output.
10. AC Input Connection
input. On the MMS1012-G model, the strain relief comes with an
attached fl exible AC input power cord.
11. DC Ground Terminal – a connection that is used to tie the
exposed chassis of the inverter to the DC grounding system.
Accepts CU/AL conductors from #14 AWG (2.1 mm²) to #6 AWG
(13.3 mm²).
12. GFCI Outlet – Ground Fault Circuit Interrupter outlet (with test
and reset capability). MMS1012-G models only.
4
1
12
8
10
9
– a strain relief clamp for hardwiring AC
© 2017 Sensata Technologies
2
5
3
6
4
11
7