Installation; Pre-Installation; Unpacking And Inspection; Locating And Mounting The Inverter - Magnum Energy MMS Series Owner's Manual

2.0

Installation

2.1

Pre-Installation

Before installing the inverter, read
Thorough planning will better meet your inverter needs.
WARNING:
qualifi ed personnel (licensed or certifi ed electrician).
The installer determines which safety codes apply and
ensures that all applicable installation requirements are
followed. Applicable installation codes vary depending on
the specifi c location and the type of installation.
Info: Review the Important Product Safety Information
and Important Battery Safety Instructions on pages ii-vi
before any installation.
The basic system diagrams shown in Figures 2-1 and 2-2
reviewed to assist you in planning and designing your installation.

2.1.1 Unpacking and Inspection

Carefully remove the MMS inverter/charger from its shipping container
and inspect all contents. Verify the following items are included:
• MMS Series inverter/charger
• Red and black DC terminal covers
• AC access cover with two screws
• Two 5/16-18 hex-head kep nuts (installed on the DC terminals)
• Battery Temperature Sensor (BTS)
• MMS Series Owner's Manual
• Warning Label
If items appear to be missing or damaged, contact your authorized
Magnum Energy dealer or Sensata Technologies. If at all possible,
keep your shipping box. It will help protect your inverter from damage
if it ever needs to be returned for service. Save your proof-of-purchase
as a record of your ownership (needed for any in-warranty service).
Record the unit's model and serial number in the front of this manual
in case you need to provide this information in the future. It is much
easier to record this information before the unit has been installed.

2.1.2 Locating and Mounting the Inverter

WARNINGS:
• Do not mount the inverter near any fl ammable or
combustible fl uid or components.
• Provide adequate clearance/ventilation to the inverter.
• Mount only on a non-combustible surface.
• Maximum ambient temperature around the inverter
must not exceed 77°F (25°C) to meet continuous power
output specifi cations.
© 2017 Sensata Technologies
the entire Installation section.
Installations should
Installation
be performed by
should be
7