Figure 1-3, Left Side Features - Magnum Energy MS-PAE Series Owner's Manual

Introduction
The left side of the MS-PAE Series is equipped with the following features (refer to fi gure 1-3):
Exhaust Air Vent - ventilation openings that allows heated air to be removed by the
13
internal cooling fan.
Model/Serial Number Label - includes model/serial number information, date of
14
manufacture and inverter and charger specifi cations. See the MS-PAE Specifi cations
in Appendix A for more information and the different models available.
AC Access Cover - provides access to the internal AC wiring terminal block. This terminal
15
block is used to hardwire all inverter AC input and output wiring connections. Remove the
two screws to access the AC wiring terminal block.
Input circuit breakers - these circuit breakers protect the unit's internal wiring and
16
pass-thru relay on each input (L1 and L2) while in the standby mode. These input circuit
breakers are not branch-circuit rated. These circuit breakers pop out when they open,
press in to reset power capacity.
CAUTION: Circuit breakers that branch-circuit rated must be installed in the invert-
er's input and output wiring.
CAUTION: The inverter's internal AC transfer relay is rated for 30 amps per leg, the
pass-thru current must be no greater than 30 amps per leg or damage to the relays
may occur.
1 3
E
XHAUST
A V
IR ENTS
( )
BACK SIDE

Figure 1-3, Left Side Features

Page 4
M
ODEL
1 4
N
UMBER
1 6
I C B
NPUT IRCUIT REAKERS
/S
ERIAL
L
ABEL
AC A
1 5
C
© 2009 Magnum Energy Inc
CCESS
OVER