Wheel Bolt Cover Caps; Full Wheel Frame - Skoda Octavia 2020 Owner's Manual

Hide thumbs Also See for Octavia 2020:
Table of Contents

Advertisement

Fitted snow chains.
Save tyre pressure values
Save tyre pressure values
Release the button
the button under the Info-
tainment.
Tap the functional area
the Infotainment.
Then follow the instructions on the screen.
Save the tyre pressure values in the following cases.
Change in tyre pressure.
Change of one or more wheels.
Change of position of a wheel on the vehicle.
Always after covering a distance of 10,000 km or
once a year.
Troubleshooting
Tyre pressure display faulty
flashes for about 1 minute and stays on
Stop the vehicle, switch off the ignition and
start the engine.
If the
symbol flashes again after starting the en-
gine, there is a system fault.
Continue driving, exercising appropriate caution,
and seek the help of a specialist garage.

Wheel bolt cover caps

Pull off and install cover caps
Pull off
Push the pull-off clamp onto the cover cap up to
the stop.
Pull off the cover cap.
Install
Push the cover cap onto the wheel bolt to the stop.
in the menu displayed in
Wheels ›
Wheel bolt cover caps

Full wheel frame

Pull off panel and install
Applies to factory installed covers or covers deliv-
ered with ŠKODA original accessories.
Remove
Hang the bracket for pulling off the wheel covers
at the edge of one of the openings in the cover.
Push the wheel wrench through the bracket, sup-
port it on the tire and pull off the cover.
Install
Place the cover on the intended valve section on
the rim.
If an anti-theft wheel bolt is used, it must be in the
position marked on the cover.
Press the trim, starting at the valve, into the rim on
both sides until it engages around the entire cir-
cumference.
NOTICE
Use hand pressure, do not hit the wheel cover.
169

Advertisement

Table of Contents
loading

Table of Contents