Table of Contents
Advertisement
Tyre pressure monitor
Functionality
The tyre pressure monitoring indicator indicates a
change in tyre pressure.
Warning when pressure changes
illuminates
›
Stop the vehicle.
›
Check the tyres and tyre pressures.
Show tyres with changed pressure
›
In the following menu, select the menu item for
displaying the tyre condition.
Or:
Functional restriction
The system is unable to provide a warning in the
event of a very rapid tyre pressure loss, e.g. sudden
puncture.
The system function may be restricted in the follow-
ing cases.
Uneven loading of the wheels, e.g. with a trailer at-
▶
tached.
Sports driving style.
▶
Driving on unpaved roads.
▶
Fitted snow chains.
▶
Save tyre pressure values
Save tyre pressure values in Infotainment
›
Inflate the tyres to the stipulated inflation pressure.
›
Turn on the ignition.
›
In the following menu, select the menu item for
displaying the vehicle condition.
Or:
›
Using the functional areas
the tyre control display.
›
Tap the functional surface
›
Then follow the instructions on the screen.
Save tyre pressure values with the button
›
Inflate the tyres to the stipulated inflation pressure.
›
Turn on the ignition.
›
Release the button
down.
The indicator light lights up in the instrument clus-
ter
from the isolation box. After storing the tyre
pressure values, an acoustic signal sounds and the
warning light goes out.
›
Release the button
Save the tyre pressure values in the following cases.
Change in tyre pressure.
▶
Change of one or more wheels.
▶
Change of position of a wheel on the vehicle.
▶
Always after covering a distance of 10,000 km or
▶
once a year.
Troubleshooting
Tyre pressure display faulty
start the engine.
If the
gine, there is a system fault.
›
Continue driving, exercising appropriate caution,
and seek the help of a specialist garage.
Wheel bolt cover caps
Pull off and install cover caps
Pull off
›
Push the pull-off clamp onto the cover cap up to
the stop.
›
Pull off the cover cap.
Install
›
Push the cover cap onto the wheel bolt to the stop.
select the menu for
Full wheel frame
.
Pull off panel and install
Applies to factory installed covers or covers deliv-
ered with ŠKODA original accessories.
Remove
›
Hang the bracket for pulling off the wheel covers
at the edge of one of the openings in the cover.
Wheels ›
Tyre pressure monitor
.
flashes for about 1 minute and stays on
›
Stop the vehicle, switch off the ignition and
symbol flashes again after starting the en-
133
Advertisement
Table of Contents
