Table of Contents
Advertisement
Set the brightness of the instrument cluster light-
ing
The brightness is adjusted automatically according
to the given lighting conditions.
The manual brightness adjustment is carried out as
follows when the dipped beam is switched on.
›
In Infotainment, select the following menu.
Interior Ambient light
›
Make the setting.
Or:
›
In Infotainment, select the following menu.
Interior Ambient lighting
›
Make the setting.
Set the variant of the display
›
Press the
button or on the multifunction steer-
ing wheel to change the variant of the display pre-
sentation.
Select the variants shown
Depending upon vehicle equipment:
Classic display
A
Navigation display
B
Driver assistants
C
Basic display
D
Sporty display (depending on equipment)
E
Driving data
Overview
The driving data display works with the ignition
switched on.
In the instrument cluster display
Depending on the equipment, the display of the in-
strument cluster shows information such as speed,
fuel consumption, range, etc.
For natural gas vehicles, the display of the instru-
ment cluster shows the natural gas quality in percent
Driver information system ›
from 70 % to 100 %. The higher the value, the lower
the consumption of natural gas.
In Infotainment
The following information is displayed in the Info-
tainment.
Travelled distance
Driving time
Average speed
Average fuel consumption
Range
Storage
The system saves the driving data in the following
memories.
Since start
Driving data from the time of switching on the ig-
▶
nition until the ignition is switched off again is stor-
ed in the memory. If the journey is interrupted for
more than 2 hours, the memory will be reset.
Long-term
The driving data of all trips up to a total of 99
▶
hours and 59 minutes driving time or 9999 km
driving distance are stored in the memory. If one of
the listed values is exceeded, the memory is reset.
Since refuel
Driving data from the last fuel tank are stored in
▶
the memory. The memory is reset the next time
the tank is filled.
Operation
Display driving data in the display of the instru-
ment cluster via the operating lever
›
Select the menu item for the driving data in the
main menu in the instrument cluster display.
Display driving data in the display of the instru-
ment cluster via the multi-functional steering
wheel
Applies to the analogue instrument cluster.
›
Select the menu item for the driving data in the
main menu in the instrument cluster display.
Driving data
67
Press - Select en-
A
try / set values
Press - Confirm en-
B
try
Advertisement
Table of Contents
