Tyre pressure monitor
Functionality
The tyre pressure monitoring indicator indicates a
change in tyre pressure.
Warning when pressure changes
illuminates
›
Stop the vehicle.
›
Check the tyres and tyre pressures.
Function restriction
The system is unable to provide a warning in the
event of a very rapid tyre pressure loss, e.g. sudden
puncture.
The system function may be restricted in the follow-
ing cases.
Uneven load on the wheels.
▶
Sporty driving style.
▶
Driving on dirt roads.
▶
Snow chains fitted.
▶
Saving tyre pressure values
Save tyre pressures with the button
The button for storing tyre pressure values is located
in the storage compartment on the front passenger
side.
›
Inflate the tyres to the prescribed inflation pres-
sure.
›
Turn on the ignition.
›
Keep the
button pressed down.
The warning light in the instrument cluster illumi-
nates
from the isolation box. After storing the
tyre pressure values, an acoustic signal sounds and
the warning light goes out.
›
Release the button
.
Save the tyre pressures in the following cases.
Change of tyre pressure.
▶
Change of one or more wheels.
▶
Change of position of a wheel on the vehicle.
▶
Always after covering a distance of 10,000 km or
▶
once a year.
Troubleshooting
Tyre pressure display faulty
flashes for about 1 minute and stays on
›
Stop the vehicle, switch off the ignition and
start the engine.
Wheels ›
Tyre pressure monitor
If the symbol
flashes again after starting the en-
gine, there is a system fault.
›
Continue driving, exercising appropriate caution,
and seek the help of a specialist garage.
Wheel bolt cover caps
Remove cover caps and install
Disconnecting
Installing
›
Push the cover cap onto the wheel bolt to the stop.
Full wheel frame
Removing and installing the trim
Applies to factory built or original accessory trims
from ŠKODA.
Disconnecting
›
Hang the clamps for removing the wheel trims at
the edge of one of the openings in the trim.
›
Push the wheel wrench through the clamp, support
on the tyre and pull off the wheel trim.
Installing
›
Press the wheel trim onto the wheel rim at the
designated valve opening.
When using an anti-theft wheel bolt, it must be lo-
cated at the location indicated on the bezel.
›
Press the trim, starting at the valve, into the rim on
both sides until it engages around the entire cir-
cumference.
NOTICE
Use hand pressure, do not hit the wheel cover.
▶
77
›
Push the pull-off clamp
onto the cover cap up
to the stop.
›
Remove the cover cap.