168 Wheels ›
Wheel bolt cover caps
Instrument cluster / Infotainment
Tyre pressure
A
Recommended tyre pressure
B
Tyre pressure not available
C
Tyre pressure too low
D
Adjust the vehicle's loading condition
E
The tyres warm up while driving and there is an
increase in pressure. This is completely normal, it is
not a defect. If the system indicates an increase in
pressure while driving, do not reduce the pressure.
Settings
Tyre type
Select the tyre type in the following menu.
Or:
Vehicle loading condition
›
In the following menu, select the menu item for
displaying the vehicle condition.
Or:
›
Using the functional surfaces
Pressure Monitoring menu item.
›
Tap the
functional area and select the vehicle
load condition.
Troubleshooting
Functional restriction / system fault
flashing
›
Stop the engine and start again.
›
If the indicator light flashes again after the engine
starts, there is a problem with the system.
›
Continue driving, exercising appropriate caution,
and seek the help of a specialist garage.
Wheel bolt cover caps
Remove cover caps and install
Disconnecting
›
Push the pull-off clamp onto the cover cap up to
the stop.
›
Remove the cover cap.
Installing
›
Push the cover cap onto the wheel bolt to the stop.
Full wheel frame
Removing and installing the trim
Applies to factory built or original accessory trims
from ŠKODA.
Disconnecting
›
Hang the clamps for removing the wheel trims at
the edge of one of the openings in the trim.
›
Push the wheel wrench through the clamp, support
on the tyre and pull off the wheel trim.
Installing
›
Press the wheel trim onto the wheel rim at the
designated valve opening.
When using an anti-theft wheel bolt, it must be lo-
cated at the location indicated on the bezel.
›
Press the trim, starting at the valve, into the rim on
both sides until it engages around the entire cir-
choose the Tyre
cumference.
NOTICE
Use hand pressure, do not hit the wheel cover.
▶