approved tyre sizes for your vehicle. These are
listed in the technical vehicle documentation and
in the declaration of conformity (in the so-called
COCDocument).
Tyre pressure reading for the front axle tyres
D
Tyre pressure reading for the rear axle tyres
E
Prescribed tyre pressure value for the emergen-
F
cy wheel
Tyre pressure monitor
Functionality
The tyre pressure monitoring indicator indicates a
change in tyre pressure.
Warning when pressure changes
illuminates
›
Stop the vehicle.
›
Check the tyres and tyre pressures.
Show tyres with modified pressure
In the following menu, select the menu item for dis-
playing the tyre condition.
Or:
Tyres
Function restriction
The system is unable to provide a warning in the
event of a very rapid tyre pressure loss, e.g. sudden
puncture.
The system function may be restricted in the follow-
ing cases.
Uneven loading of the wheels, e.g. with a trailer at-
▶
tached.
Sporty driving style.
▶
Driving on dirt roads.
▶
Snow chains fitted.
▶
Inflation pressure for
A
half load
Inflation pressure for
B
a full load
Tyre diameter in in-
C
ches
This information only
serves as informa-
tion for the prescri-
bed tyre pressure.
This is not a listing of
Wheels ›
Tyre pressure monitor
Saving tyre pressure values
Saving tyre pressure values
›
Press the
button under the Infotainment.
›
In the displayed menu in Infotainment, tap the
functional surface
.
›
Then follow the instructions on the screen.
Save the tyre pressures in the following cases.
Change of tyre pressure.
▶
Change of one or more wheels.
▶
Change of position of a wheel on the vehicle.
▶
Always after covering a distance of 10,000 km or
▶
once a year.
Troubleshooting
Tyre pressure display faulty
flashes for about 1 minute and stays on
›
Stop the vehicle, switch off the ignition and
start the engine.
If the
symbol flashes again after starting the en-
gine, there is a system fault.
›
Continue driving, exercising appropriate caution,
and seek the help of a specialist garage.
Wheel bolt cover caps
Remove cover caps and install
Disconnecting
›
Push the pull-off clamp onto the cover cap up to
the stop.
›
Remove the cover cap.
Installing
›
Push the cover cap onto the wheel bolt to the stop.
Full wheel frame
Removing and installing the trim
Applies to factory built or original accessory trims
from ŠKODA.
159