Table of Contents
Advertisement
214 Wheels ›
Wheel bolt cover caps
›
In the following menu, select the menu item for
displaying the vehicle condition.
Or:
›
Using the functional areas
the tyre control display.
›
Tap the functional surface
›
Then follow the instructions on the screen.
Save the tyre pressure values in the following cases.
Change in tyre pressure.
▶
Change of one or more wheels.
▶
Change of position of a wheel on the vehicle.
▶
Always after covering a distance of 10,000 km or
▶
once a year.
Troubleshooting
Tyre pressure display faulty
flashes for about 1 minute and stays on
›
Stop the vehicle, switch off the ignition and
start the engine.
If the
symbol flashes again after starting the en-
gine, there is a system fault.
›
Continue driving, exercising appropriate caution,
and seek the help of a specialist garage.
Wheel bolt cover caps
Pull off and install cover caps
Pull off
›
Push the pull-off clamp onto the cover cap up to
the stop.
›
Pull off the cover cap.
Install
›
Push the cover cap onto the wheel bolt to the stop.
Full wheel frame
Pull off panel and install
Applies to factory installed covers or covers deliv-
ered with ŠKODA original accessories.
Remove
select the menu for
›
Hang the bracket for pulling off the wheel covers
at the edge of one of the openings in the cover.
.
›
Push the wheel wrench through the bracket, sup-
port it on the tire and pull off the cover.
Install
›
Place the cover on the intended valve section on
the rim.
If an anti-theft wheel bolt is used, it must be in the
position marked on the cover.
›
Press the trim, starting at the valve, into the rim on
both sides until it engages around the entire cir-
cumference.
Use hand pressure, do not hit the wheel cover.
▶
Pull off and install the aero cover
Applies to factory installed covers or covers deliv-
ered with ŠKODA original accessories.
Remove
›
Hook the bracket to remove the wheel covers at
the edge of the panel as close to the centre as pos-
sible.
›
Loosen the centre of the wheel cover by pulling
and pull off the cover.
wheel wrench through the bracket loop and pull on
the two key ends.
Install
›
If an anti-theft wheel bolt is used, it must be in the
position marked on the cover.
›
Place the cover on the wheel rim and press in the
individual spokes of the cover one after the other
until they engage completely.
›
Press in the centre of the wheel cover until it clicks
into place.
NOTICE
To make removal easier, it is possible to insert the
Advertisement
Table of Contents
