Configure Beaglebone To Connect To Wlan Network - Keysight Technologies U3810A Getting Started Manual

Configure BeagleBone to Connect to WLAN network

Once this connection has been established for the first time, it will automatically connect back on
subsequent reboots.
1
In the PuTTY terminal window, enter connmanctl to start the wireless connection manager.
2 Enter technologies to verify the WLAN function is available.
debian@beaglebone:~$ connmanctl
connmanctl> technologies
/net/connman/technology/p2p
/net/connman/technology/wifi
/net/connman/technology/bluetooth
connmanctl>
NOTE
3 Enter the scan wifi command to search the available networks.
connmanctl> scan wifi
Scan completed for wifi
4 Type the agent on command to turn on the connection agent.
connmanctl> agent on
Agent registered
Keysight U3810 Series Getting Started Guide
Name = P2P
Type = p2p
Powered = False
Connected = False
Tethering = False
Name = WiFi
Type = wifi
Powered = True
Connected = False
Tethering = False
Name = Bluetooth
Type = bluetooth
Powered = True
Connected = False
Tethering = False
−
It is possible that you may see the following. This is an acceptable behavior and you
may proceed:
debian@beaglebone:~/LabCode/M3-L7$ connmanctl
Error getting VPN connections: The name net.connman.vpn was not
provided by any
connmanctl>
−
If you see "Powered = False" for WLAN, then it means WLAN is disabled. Enter the
enable wifi command to enable it.
38