Keysight Technologies U3810A Getting Started Manual page 64

2 Run the following command to test the connection. The result should only show Device 0x60 on
the list.
i2cdetect -r -y 1
3 Run the Barometer code with the command below.
./PressureDisplay
If the file does not exist, enter the command below to recompile the code.
NOTE
gcc M1_L1_PressureDisplay.c -l mraa -o PressureDisplay
4 Press Ctrl + C to exit the program and disconnect all jumper wires from DIGITAL PRESSURE
SENSOR.
Keysight U3810 Series Getting Started Guide 64