Keysight Technologies U3810A Getting Started Manual page 62

3 Run the compiled program to display both the ANALOG TEMP SENSOR and DIGITAL TEMP
SENSOR reading on the LCD display.
./ADTempDisplay
If ADTempDisplay is not already there, use the command below to compile.
NOTE
gcc M1_L1_ADTempDisplay.c -l mraa -o ADTempDisplay
The program will display both TMP36 and LM75 on LCD as shown below.
4 Press Ctrl + C to exit the program and disconnect all jumper wire connections.
Keysight U3810 Series Getting Started Guide 62