Uninitialized Beaglebone Devices - Keysight Technologies U3810A Getting Started Manual

Uninitialized BeagleBone devices

You will only need to perform this when the BeagleBone LEDs do not scan and turn off after 10
minutes (only for Un-initialized BeagleBones and older Debian images).
For some un-initialized BeagleBones or BeagleBones loaded with older Debian images, the USER
button on the BeagleBone will need to be pressed and held until the four blue status lights all
illuminate to install the image.
With the SDcard installed, press and hold the USER button as power is applied to the BeagleBone
by connected the USB cable to your computer. Release the button when the four LEDs illuminate.
Insert the SD
card here
IMPORTANT - Remove the SD card while the BeagleBone is powered off. No LEDs should be
active on the BeagleBone board. The SD card can be set aside and no longer needed for these
labs.
9 Press the PWR BTN to power up the BeagleBone and verify the new image by connecting with
PuTTY and observing the revision in the login notes.
Keysight U3810 Series Getting Started Guide
Hold until all four
LEDs (USR0, USR1,
USR2, and USR3)
light up.
Press and Hold
the USER button
108