Keysight Technologies U3810A Getting Started Manual page 27

6 Enter username debian and the password temppwd. A login message should appear showing the
last login and the Keysight U3810A Lab Code Version.
Last login: Fri Sep 20 16:39:16 UTC 2019 on ttyS0
The programs included with the Debian GNU/Linux system are free
software;
the exact distribution terms for each program are described in the
individual files in /usr/share/doc/*/copyright.
Debian GNU/Linux comes with ABSOLUTELY NO WARRANTY, to the extent
permitted by applicable law.
Keysight U3810A Image Version 3.57 Sept 20th 2019
debian@beaglebone:~$
7 If there is no Keysight Revision after login, please obtain an SD Card and follow the procedure in
Appendix A - Initialize BeagleBone with Keysight U3810A
8
To start with a new version of the lab code run the command sh LabCodeReset.sh -u. For this
update, enter temppwd for the sudo password.
debian@beaglebone:~$ sh LabCodeReset.sh -u
Do you want to erase before refreshing the code? (y/n) y
Erasing LabCode
Refreshing LabCode
LabCode/
LabCode/M1-L2/
LabCode/M1-L2/M1_L2_T2c_RGB_LED_PWM.c
LabCode/M1-L2/M1_L2_E1_buttons.c
...
.KS_Files/etc/environment
.KS_Files/boot/
.KS_Files/boot/uEnv.txt
LabCodeReset.sh
Updating Keysight Revisions
[sudo] password for debian: temppwd
Reboot is suggested
debian@beaglebone:~$
Keysight U3810 Series Getting Started Guide
Image.
27