Appendix G - Restore U3810A Startup Files - Keysight Technologies U3810A Getting Started Manual

Appendix G – Restore U3810A startup files
1
If you are continuing this lab from previous lab session;
a
b
c
2
Run the following command to unzip the Startup Scripts from its ZIP archive.
cd ~/LabCode
tar -xzf startup_scripts.gz
3 Execute the following command to change your working directory to the startup directory.
cd startup_scripts
4
Execute the following command to run the autodisplay.sh script. This will reset your U3810A
startup to the factory state.
sudo ./autodisplay.sh
Keysight U3810 Series Getting Started Guide
Make sure your U3810A jumper settings are set up according to
Connect your PC to the BeagleBone with a USB cable. Refer to
Communication.
Establish a secure shell communication with the BeagleBone. Refer to
connection.
Set Up the U3810A System.
Set Up Secure Shell (SSH)
Set Up SSH
120