Table of Contents
Advertisement
2.4. Power Up
After FC600 has been installed accordingly to your system (for the installation and different systems description
please refer to the Installer Section in chapter 4) it will go into STANDBY Mode. To start using your FC600 and
adjust room temperature, create schedules and operate the fan you will need to wake it up. Simply press the
button for 3 seconds. The icons on your screen will show up depending on your settings. The time
should be 12 AM.
Note: Press any button to activate the LCD first!
Note: By default, if you are using the thermostat without the Internet, it will be non-programmable, meaning
that you cannot set programs. The thermostat can be switched to programmable mode by changing the d00
parameter from 0 to 1 in Installer Mode. Find more information in the Installer Section.
You can install your thermostat in Local Mode, without using the Universal Gateway UG600 and the App. It will
run in Offline Mode. You can always switch to Online mode from Offline. Please see page 49 for details. For first
time installation without Internet, please follow the steps below:
1
M
On first activation, FC600 will
display software version.
5
M
M
Press OK
.
8
Fan Coil FC600 Instructions Manual
M
3 sec
2
M
When FC600 goes On, the LCD will
show "UG YES" flashing. Please
select "NO" using
or
,
as we are connecting the FC600
without Internet connection.
6
M
M
M
Select what is connected to
S1. By default is No function.
Please see page 41 for details.
00:00
3
M
M
Short press OK
.
7
M
Select an output for S2. the
default is No function. Please
see page 41 for details.
M
4
M
Choose your system type:
2 pipe or 4 pipe.
8
M
Please select if you want to
use your 2 pipe Fan Coil for
Cooling
only...
Advertisement
Table of Contents
