Salus FC600 Full User Manual page 55

Parameter
Type of setting
number
d36 Status after power
breakdown
d37 To allow user unlock
the keys
or NOT
d38 Manual Fan Speed
Operation
d39 FAN turning ON delay 0 seconds to 30 minutes
d40 FAN turning OFF delay 0 seconds to 30 minutes
d41 Valve control when
FAN is manually OFF
d42 Fan control available
only in COOLING
mode
* connection diagram
on the next page
d43 Allow to adjust
setpoint in device
when buttons locked
Note: Parameter d01 settings CANNOT be changed in the installer menu, neither on the device nor in
the application. It depends on the initial configuration of the thermostat and can only be changed after a
device reset (i.e. after restoring factory settings). Some parameters will be visible / invisible depending on
the setting of main parameter d01 (fan coil type: 0 = 2-pipe; 1 = 4-pipe).
55 Fan Coil FC600 Instructions Manual
Description
After the power is on, the thermostat will function in
0 = standby
1 = last configuration
1 = means user can unlock by pressing
0 = means user can NOT unlock by pressing
If d37=0, user can lock/unlock the keys, only through the
App.
0 = Fan always on (doesn't matter if the Fan Coil is calling
or not for heating or cooling)
1 = FAN works on the speed set manually, only when the
Fan Coil is calling for heating or cool
0 – (default) no valve control when fan is MANUALLY off
1 – still use valve control when fan is MANUALLY off
0 - fan control is available in all modes
1 - fan control is available ONLY in COOLING mode
0 - No
1 - Yes
Default
Values
0
and 0
and
1
0
0
0
0