Salus FC600 Full User Manual page 12

4.
The Leaf icon
that the thermostat is in Heating Mode. When in Eco Mode, the thermostat will use Eco
setpoint to control room temperature. You cannot change the temperature in Eco Mode.
M
M
M
Eco Mode
allows you to temporarily reduce energy consumption by reducing the current setpoint
temperature to a certain level, lowering the setpoint temperature when heating or raising it when cooling.
Note: When thermostat operates in Eco Mode, you cannot set a new temperature set point by pressing the
or . After thermostat exits Eco Mode, it returns to the previous set mode.
The default set point temperature is 30°C for cooling mode and 15°C for heating mode. To change that, please
refer to settings in Installer Section.
M
Note: If you have the occupancy sensor, then the Eco Mode will be activated automatically when the set up
is complete. This is the default setting. You can choose from either ECO or STANDBY mode when depending
on the position of the keycard (in/out).
If your thermostat is set to Auto Heat/Cool selection, these are the 2 possible combinations you can have by
quick press of the Mode Button:
1.
M
M
2.
M
M
M
12 Fan Coil FC600 Instructions Manual
indicates that the thermostat is in Eco Mode. The heat icon
The A icon indicates that the thermostat is running in auto heat/cool changeover
mode. The hand icon
setpoint temperature and the thermostat will follow it. The Heating/Cooling mode will
be selected automatically:
- using Heat / Cool changeover sensor connected to S1/COM (available in 2 pipe and
4 pipe application)
- using the pipe sensor connected to S1/COM (available in 2 pipe application only)
- using the "dead zone" (available in 4 pipe application only)
Eco Mode with auto heat/cool changeover. The temperature will be set using Eco
temperature setpoint. When in Eco Mode, the thermostat will use Eco set point to
control the room temperature. You cannot change the temperature in Eco mode.
shows Permanent Override Mode (manual). You can set a
M
indicates
M
M