Table of Contents
Advertisement
1
Remove the front cover by prying hooks with flat screwdriver at
the bottom of the front panel.
The ends of the connecting wires must be protected against delamination using insulated sleeves as shown in the figure
below:
3
FC600 is designed for flush mounting in a 60 mm wall box.
Make sure the back cover is in place in the appropriate position
(according to the arrow on it).
44
Fan Coil FC600 Instructions Manual
insulated sleeve with a
length of 6 mm
60 mm
2
FC600
F3
For the convenience of installation, the first step is to wire the
volt-free wires, then low-voltage wires (S1, S2, COM). Check that
wires are properly connected.
4
Fit the front part of the casing to the top edge and make sure
the pins are properly positioned. Push the front of the casing
until you hear positive click.
S2
COM
S1
F2
F1
V2
V1
N
L
Advertisement
Table of Contents
